Most Mobridge Uživatelský manuál stáhnout pdf (Strana 4)

Porsche Under-dash Installation Notes

(997 shown, Cayman very similar)

(CDR24 shown, steps are same for PCM)

1. In right passenger footwell, (if cover is

equipped) remove foam cover pad behind the

dashboard. It may not be completely necessary to

remove this piece but may allow for better access.

mObridge unit is installed behind the climate

control unit and below the CDR24, accessible via

this panel.

2. The small carpeted piece that houses the

power plug must be removed. There is one Torx

type screw affixing this piece in place, which can

be found hidden beneath a small hole in the

carpeting. Note that sometimes this screw feels

like it is threading in and out very difficultly, but this

is normal – it is the normal feeling of the fit

between the screw and the clip that it screws into.

After unscrewing, slide the small carpeted piece

out as shown. It may make the job easier to

unplug the power plug’s connector to completely

remove the piece.

slide

Remove

Torx

screw

Remove foam

underpanel, if necessary

3. You should now have access to the two Torx

screws that secure the side panel flanking the

center console. Remove these,

Note: Alternate Step-by-Step Instructions

for CDR24 or PCM2 removal in 997 and 987

can be found later in this document.

page 4 of 14

1 2 3 4 5 6 7 8 9 ... 13 14

Žádné komentáře

Most Mobridge Uživatelský manuál Strana 4